Table of Contents
Advertisement
B. Internet status indicator (2-pin LAN1_LED, LAN2_LED)
These two 2-pin headers allow you to use the Gigabit internet
indicator cable to connect to the LAN status indicator. When this
indicator flickers, it means that the internet is properly connected.
C. Chassis intrusion pin (2-pin CHASSIS)
This header is provided for host computer chassis with chassis
intrusion detection designs. In addition, it must also work with
external detection equipment, such as a chassis intrusion
detection sensor or a microswitch. When this function is activated,
if any chassis component movement occurs, the sensor will
immediately detect it and send a signal to this header, and the
system will then record this chassis intrusion event. The default
setting is set to the CASEOPEN and GND pin; this function is off.
D. Locator LED (6-pin LOCATOR)
This header is for the locator switch and LED on the front panel.
Speaker Header
(4-pin SPEAKER1)
(see p.16, 19, 22, 24, 27, 30)
Front and Rear
Fan Connectors
(4-pin FRNT_FAN1)
(4-pin FRNT_FAN2)
(4-pin FRNT_FAN3)
(4-pin FRNT_FAN4)
(see p.15,18,21)
(4-pin FRNT_FAN2)
(4-pin FRNT_FAN3)
(4-pin FRNT_FAN4)
(see p.24, 27, 30)
(4-pin REAR_FAN1)
(see p.16, 19, 22, 25, 28, 31)
(4-pin REAR_FAN2)
(see p.16,19, 22)
(4-pin REAR_FAN2)
(see p.25, 28, 31)
GND
+12V
CPU_FAN_SPEED
FAN_SPEED_CONTROL
GND
+12V
CPU_FAN_SPEED
FAN_SPEED_CONTROL
FAN_SPEED_CONTROL
CPU_FAN_SPEED
+12V
GND
58
Please connect the speaker
to this header.
Please connect the fan
cables to the fan connectors
and match the black wire to
the ground pin. All fans sup-
ports Fan Control.
Advertisement
Table of Contents
