Ford 2008 Explorer Owner's Manual page 60

Driver Controls
If the indicator light(s) underneath the house icon blink rapidly for two
seconds and then turn to a continuous light, proceed with steps 6
through 8 to complete programming of a rolling code equipped device.
6. At the garage door opener receiver (motor-head unit) in the garage,
locate the "learn" or "smart" button (usually near where the hanging
antenna wire is attached to the unit).
7. Press and release the "learn" or "smart" button. (The name and color
of the button may vary by manufacturer.)
Note: There are 30 seconds in which to initiate step eight.
8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink button. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLink should now activate your rolling code equipped device. To
program additional HomeLink buttons begin with step 2 in the
"Programming" section. For questions or comments, please contact
HomeLink at www.homelink.com or 1–800–355–3515.
Gate operator & Canadian programming
During programming, your hand-held transmitter may automatically stop
transmitting — not allowing enough time for HomeLink to accept the
signal from the hand-held transmitter.
After completing steps 1 and 2 outlined in the "Programming" section,
replace step 3 with the following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the "cycling" process to prevent
overheating.
• Continue to press and hold the
HomeLink button (note step 3
in the "Programming" section)
while you press and release —
every two seconds ("cycle")
your hand-held transmitter until
the frequency signal has been
accepted by the HomeLink . The
message CHANNEL "X" (1,2 or 3)
TRAINING will appear on the
display.
• Proceed with step 4 in the "Programming" section.
60
2008 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)