Preparing For Ez Gig Ii - Apricorn EZ Upgrade Upgrade Kit

Preparing for EZ Gig II Data Transfer
After many years of use, hard drives can become cluttered with unusable file
fragments and other file-system errors. Most file system errors are not immediately
obvious to the user, but can be identified and repaired with a few simple steps.
Although the steps below are not absolutely necessary to run EZ Gig, it's best to
try and clean-up disk errors BEFORE they are copied over to the new drive.
Before running EZ Gig II we recommend you:
1) Clean up any file-system errors by running Windows ScanDisk (or
a similar disk cleanup utility) on your internal hard drive.
2) Defragment your hard drive using the Windows Disk-Defragment
Utility (or a similar disk defragment utility) on your internal hard
drive.
3) Backup any critical files or data.
4) Attach the AC adapter to your laptop, and make sure it is not
running on battery power.
5) Attach the USB cable from your computer to the EZ Upgrade.
6) If you plan on running EZ Gig II from the Bootable CD-ROM: You
may need to change your laptop's BIOS boot order. You will find
these options inside the laptop's BIOS Boot Option Menu. The
BIOS Boot Options menu allows the user to select the preferred
boot device when the laptop starts up. EZ Gig II can boot directly
from the CD-ROM but you must check the BIOS Boot settings to
make sure that "CD-ROM" is higher in the boot order than the C:
drive.
EZ Upgrade
www.apricorn.com
Hard Drive Upgrade Kit
pg.