AOpen AX4PE Max Online Manual page 102

A X 4 P E M a x
A X 4 P E M a x
************************************************
Installing Driver During New Windows
****************************************************
1 . Start the installation:
a. Floppy Install: Boot the computer with the Windows XP installation diskettes.
b. Floppyless Install: Boot from floppy and type "WINNT". After files have been copied, the system will reboot. On the reboot,
press <F6> after the message "Setup is inspecting your computer's hardware configuration..." appears.
c. CD-ROM Install: Boot from the CD-RO
RAID driver" appears.
2. When the "Windows XP Setup" window is
3. Insert the Promise SATA150 driver diskette into dri
4. Use " " or " " to choose "WinXP Promise SATA
↑ ↓
press the "Enter" key.
5. Press "S" to use the driver on the floppy disk, and then
"Windows default driver", you will encounter the following error message in the next
any hard disk drives installed in your computer"
NOTE: Restart installation and then use option "S" to load driver from floppy disk.
6. The Windows XP Setup screen will appear again saying, "Setup will load su
list will include "WinXP Promise SATA TX2plus (tm) IDE Controller".
NOTE: If you need to specify any additional devices to be installed, do
Once all devices are specified, continue to the next step -
6 . From the Windows XP Setup screen, press the Enter key. Setup will now load all device files and then continue the
Windows XP installation.
****
XP Installation
M. Press <F6> after the message "Press F6 if you need to install third party SCSI or
generated, press "S" to Specify an Additional Device(s)
ve A: and press "Enter" key.
TX2plus (tm) IDE Controller" from the list t
press "enter" to continue with installation. If you press "enter" to use
102
O
O
hat appears on screen, and then
phase of the installation: "Setup did not find
pport for the following mass storage devices:" The
so at this time.
n l i n e M a n u a l
n l i n e M a n u a l