AOpen AX4PE Max Online Manual page 100

A X 4 P E M a x
A X 4 P E M a x
Windows NT 4.x Installation Guide
**************************************************
Installing Drivers During New Windows NT 4.0 Installation
*********************************************************
1. Start the system installation by booting from the Windows NT
a. Floppy install: boot the system with the Windows
b. Floppyless install: boot from floppy and type "WINNT /B". After
reboot, press the "F6" key when the message
"Setup is inspecting your computer's hardware configuration..." appears.
c. CD-ROM disk install: boot from the CD-ROM disk and press
computer's hardware configuration..." appears.
2. When the "Windows NT Setup" window is generated, press "S" to specify a
3. Use "↑" or "↓" to select "Other" and press the "Enter" k
4. Insert the driver diskette into drive A: and press th
5 . Choos e "WinNT Promise SATA TX2plus (tm)
k ey.
6. The Windows NT Setup screen will appear again saying, "Setup will load support for
list will include "WinNT Promise SATA TX2plus (tm) IDE Controller".
NOTE: If you need to specify an
t o the next step -
7. From the Windows NT Setup screen, press
files and then continue the Windows
8. After a successful installation, the "SCSI Adapter Setup" box will s
Promise SATA TX2plus (t
*******
NT inst
e "Enter"
ID E Controller" from the list that appears on screen,and then press the "Enter"
y additional devices to be installed, do so at th
the Enter key. Setup will now load all device
NT inst allation.
m) IDE Controller" driver has been insta
disk:
allation diskettes.
files have been copied, the system will reboot. On the
the "F6" key when the message "Setup is inspecting your
n Additional Device(s).
ey.
key.
is time. Once all devices are specified, continue
how that the "WinNT
lled.
100
O n l i n e M
O n l i n e M
the following mass storage devices:" The
a n u a l
a n u a l