Table of Contents
Advertisement
A
X
4
P
E
M
a
x
A
X
4
P
E
M
a
x
***********************************************
Installing Drivers with Existing Windows NT 4.0
***********************************************
WARNING: If you wish to use your current bootable drive with the Windows NT4 operating system on the SATA150, perform the
steps below while the boot drive is still attached to your existing onboard IDE con
S
ATA150 until the steps below are complete.
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel" from the "Settings" menu.
3. Double-click on the "SCSI Adapters" icon, which generates the "SCSI Adapters" dialog box.
4. Choose "Drivers," and then press "Add."
5. In the "Install Drivers" dialog box, press "Have Disk..."
6.
When the "Install From Disk" appears, Insert the driver diskette into drive A:, then
choose "OK."
7
. When the "Install Driver" dialog box appears, select "WinNT Prom
Controller" and then press "OK."
8
. When the "S
elect SCSI Adapter Option" dialog box appears, press "Install."
9. After a successful installation, the "SCSI Adapter Setup" box will show that the "WinNT
Promise SATA TX2plus (tm) IDE Controller" driver
1 . Power off your system, and then attach your hard drive(s) to the SATA
0
Windows XP Installation Guide
troller. Do not attach any drives to your
ise SATA TX2plus (tm) IDE
has been installed.
150 controller.
101
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
- Quick Links:
- Motherboard Map
Hide quick links:
Advertisement
Table of Contents
