To Adjust The Cross-Bar (If Equipped) Position:; To Remove The Cross-Bar (If Equipped) Assembly: - Ford 2005 Freestar Owner's Manual

Driver Controls

To adjust the cross-bar (if equipped) position:

1. Loosen the thumbwheel at both
ends of the cross-bar (both
cross-bars are adjustable).
2. Slide cross-bar to the desired
location and tighten the thumbwheel
at both ends of the cross-bar.

To remove the cross-bar (if equipped) assembly:

1. Loosen the thumbwheel (2) at both ends of the cross-bar (1) and
slide the cross-bar (1) to the end of the side rails (4).
2. Remove the two thumbwheels (2), clamps (3) and cross-bar (1) from
the side rails (4).
To install the cross-bar (if
equipped) assembly:
Note: Ensure that both cross-bars
are installed with the arrow, located
on the bottom of the cross-bar end,
facing towards the front of the
vehicle.
1. Position the cross bar (1) on the
side rails (4) with the arrow facing
towards the front of the vehicle.
2. Align the clamps (3) under the side rails (4) and install the
thumbwheels (2) through the cross bar (1) and side rails (4) into the
clamps (3). Repeat steps 1 and 2 to install the other cross-bar.
Note: When the cross-bars are not in use, remove or move the
cross-bars to the back of the roof rack for optimum wind noise.
93
2005 Freestar (win)
Owners Guide (post-2002-fmt)
USA (fus)