Tcp/Ip Settings Dialog; Serial Port Settings Dialog - AMX IREdit Operation/Reference Manual

Communications and File Transfers

TCP/IP Settings dialog

With TCP/IP selected as the Transport Connection Option, click Settings in the Communications Settings
dialog to open the TCP/IP Settings dialog (FIG. 51):
FIG. 51 TCP/IP Settings dialog
TCP/IP Settings dialog Options
TCP/IP Address
IP Port
Automatically ping the master
controller to ensure availability
OK
Cancel

Serial Port Settings dialog

With Serial selected as the Transport Connection Option, click Settings in the Communications Settings
dialog to open the Serial Port Settings dialog (FIG. 52):
FIG. 52 Serial Port Settings dialog
Serial Port Settings dialog Options
Com Port
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control Click the down arrow to open a menu where you can choose the Flow Control
38
Enter a valid target TCP/IP Address.
The IP Port assignment defaults to 1319.
You should not change the IP Port number.
This option prompts the program to ping the target IP address to ensure that
the Master is available.
Click to save changes and close this dialog.
Click to discard changes and close this dialog.
Click the down arrow to open a menu where you can choose between available COM ports.
Click the down arrow to open a menu where you can choose the baud rate of your COM port
from the list (suggested setting = 38400).
Click the down arrow to open a menu where you can choose the Data Bits
(suggested setting = 8).
Click the down arrow to open a menu where you can choose the parity
(suggested setting = none).
Click the down arrow to open a menu where you can choose the Stop bit(s)
(suggested setting = 1).
(suggested setting = none).
IREdit IR Library Management