Advertisement
Color Burst 8 DMX
System Menu
Color Burst 8 DMX
System Menu
On-Board System Menu.
The Color Burst 8 DMX comes with an
easy to navigate system menu. This next section will detail the func-
tions of each command in the system menu. Please read the next
section thoroughly!
To access the main menu press the MENU button. Tap the UP or
DOWN buttons until you reach function you wish to change. When you
reach the function you wish to change press the ENTER button. When
a function is selected use the UP or DOWN buttons to change the func-
tion settings. Once your changes are made press the ENTER button,
and then press and hold the MENU button for at least three seconds
to confirm and lock the change into the system memory. If the MENU
button is not pressed and held within eight seconds the fixture will
automatically confirm and lock the change into the system memory. To
exit without making any changes press the MENU button.
Addr
- DMX Address Setting via control board -
1. Tap the MENU button until "Addr" is displayed, press ENTER.
2. "X" will now be displayed, "X" represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, and then press and hold the MENU button
for at least three seconds to assign.
SLNd -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Tap the MENU button until "SLND" is displayed, press ENTER.
Either "MAST", "SL 1" or "SL 2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim.
NotE: In a Master/Slave configuration you can make one fixture the
Master and then set the next fixture to "SL 2", the fixtures will now
.
have contrast movement to each other
SHNd: SH 0 - SH 12
- Show modes 0 - 12 (Fade Program
and Factory programs). You can run show mode with sound
American DJ Supply
- www.americandj.com - Color Burst 8 DMX - Page 7
American DJ Supply
- www.americandj.com - Color Burst 8 DMX - Page 8
©
®
©
®
Advertisement
