Gate Operator And Canadian Programming; Operating The Homelink Universal Transceiver - Ford 2002 Explorer Owner's Manual

Controls and features
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink to accept the signal
from the hand-held transmitter.
After completing steps 1 and 2
outlined in the "Programming"
section, replace step 3 with the
following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the "cycling" process to prevent
overheating.
• Continue to press and hold the HomeLink button (note step 3 in the
"Programming" section) while you press and release — every two
seconds ("cycle") your hand-held transmitter until the frequency
signal has been accepted by the HomeLink . The red indicator light
will flash slowly and then rapidly after HomeLink accepts the radio
frequency signal.
• Proceed with step 4 in the "Programming" section.

Operating the HomeLink Universal Transceiver

To operate, simply press and release
the appropriate HomeLink button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
Homelink at www.homelink.com or 1–800–355–3515.
106