Conditions Of Operation; Safety Belt Maintenance - Ford 1998 Ranger Owner's Manual

Seating and safety restraints

Conditions of operation

If...
The driver's safety belt is not
buckled before the ignition switch
is turned to the ON position...
The driver's safety belt is buckled
while the indicator light is
illuminated and the warning chime
is sounding...
The driver's safety belt is buckled
before the ignition switch is turned
to the ON position...

Safety belt maintenance

Check the safety belt systems periodically to make sure they work
properly and are not damaged. Check the safety belts to make sure there
are no nicks, wears or cuts. All safety belt assemblies, including
retractors, buckles, front seat belt buckle assemblies (slide bar)
(if equipped), shoulder belt height adjusters (if equipped), child safety
seat tether bracket assemblies (if equipped), and attaching hardware,
should be inspected after a collision. Ford recommends that all safety
belt assemblies used in vehicles involved in a collision be replaced.
However, if the collision was minor and a qualified technician finds that
the belts do not show damage and continue to operate properly, they do
not need to be replaced. Safety belt assemblies not in use during a
collision should also be inspected and replaced if either damage or
improper operation is noted.
Failure to replace the safety belt assembly under the above
conditions could result in severe personal injuries in the event of
a collision.
Refer to Cleaning and maintaining the safety belts in the
Maintenance and care section.
46
Then...
The safety belt warning light
illuminates for one to two minutes
and the warning chime sounds for
four to eight seconds.
The safety belt warning light and
warning chime turn off.
The safety belt warning light and
indicator chime remain off.