Listening To The Radio; Listening To Am/Fm Stations - Onkyo TX-8030 Instruction Manual

Listening to the Radio

INPUT

Listening to AM/FM Stations

With the built-in tuner, you can enjoy AM and FM radio
stations.
1 Use the receiver's [INPUT] selector, or the
remote controller's INPUT SELECTOR
buttons to select AM or FM.
In this example, FM has been selected.
Band
(Actual display depends on the country.)
2 Press the [TUNING MODE] button so that
the AUTO indicator appears or disappears
from the display.
Auto Tuning
To activate this mode, press the [TUNING MODE]
button to turn on the "AUTO" indicator. In this
mode, you will receive the broadcast in stereo
sound.
Manual Tuning
To activate this mode, press the [TUNING MODE]
button to turn off the "AUTO" indicator. In this
mode, you will receive the broadcast in monaural
sound.
22
En-
TUNING F/H
TUNING MODE
Frequency
AUTO indicator
&/(
Number
buttons
D.TUN
3 Press the TUNING [] or [] button.
You can also use the remote controller's arrow
[]/[] buttons to tune the radio.
Auto Tuning
Searching stops when a station is found.
Manual Tuning
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the
frequency one step at a time.
The frequency changes in 0.05 MHz steps (or 0.05 MHz
to 0.2 MHz for North American model) for FM, and
9 kHz (or 10 kHz) steps for AM.
When tuned to a station, the TUNED indicator appears.
When tuned to a stereo FM station, the FM STEREO
indicator also appears.
TUNED
Tuning to Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
FM STEREO