Table of Contents
Advertisement
Installing the Command Module in a Mainframe
Set the extraction levers out.
Tighten the top and bottom screws to
secure the command module to the
mainframe.
NOTE: The extraction levers will
not seat the backplane connectors
on older VXIbus mainframes. You
must manually seat the connectors
by pushing in the module until the
module's front panel is flush with
the front of the mainframe. The
extraction levers may be used to
guide or remove the command
module.
To remove the command module from the mainframe,
reverse the procedure.
Chapter 1
Refer to Figure 1-3 to install the Agilent E1406A Command Module in a
C-size mainframe.
Slide the Agilent E1406A into any slot
until the backplane connectors touch.
Figure 1-3. Installing the Command Module in a VXIbus Mainframe
Seat the command module into
the mainframe by pushing in
the extraction levers.
Agilent E1406A Command Module Overview
19
Advertisement
Table of Contents
