Making Bag From Foodsaver Roll; How To Vacuum Package With Foodsaver Bags; Getting Started; How To Make A Bag From A Foodsaver Roll - FoodSaver GameSaver Deluxe V1095 Quick Start Manual

QS.1095_v2 4/29/04

Getting Started

How to Make a Bag from a FoodSaver Roll

Pull Out Bag Material
Open appliance lid and place roll into Roll Storage
1.
Compartment .
(I)
Pull out enough bag material to hold item to be
2.
vacuum packaged, plus 3 inches. Close lid.
To cut bag material, press down lightly on lid and
3.
slide Bag Cutter
(H)
to other end.
Open appliance lid and tuck roll back into Roll
4.
Storage Compartment.
Place one end of bag material across Sealing Strip
5.
, not over rubber gasket
(M)

How to Vacuum Package with FoodSaver Bags

Place Bag in Vacuum Channel
Place item(s) in bag, allowing at least 3 inches
1.
of space between bag contents and top of bag.
Open appliance lid and place open end of bag
2.
down into Vacuum Channel
Close lid.
3.
Turn Seal Control Switch
4.
or to
Vacuum and Extended Seal
juicy foods such as raw meat).
2:29 PM Page 2
Place Bag on Sealing Strip
from one end of sliding channel
, and close lid.
(L)
Set Seal Control Switch
.
(J)
to
(G) Vacuum and Seal
(for moist or
Registering your appliance is quick and easy at www.foodsaver.com.
Press and Release Lid
Turn Seal Control Switch
6.
Press down firmly on lid with both hands until
7.
motor starts, wait 3-5 seconds, then release.
Motor will continue to run.
When motor and Indicator Light
8.
open lid and remove bag.
Now you are ready to vacuum package with your
new bag (see below).
Press and Release Lid
To begin vacuum process, press down firmly on
5.
lid with both hands until motor starts, wait 3-5
seconds, then release. Motor will continue to run.
When motor and Indicator Light turn off, open lid
6.
and remove bag. Refrigerate or freeze if needed.
(See FoodSaver Reference Guide for food safety tips.)
Let appliance cool down for 20 seconds
Note:
after each use.
to
(G) Vacuum and Seal.
turn off,
(F)