Preparing The Printer; Installing The Nic - NEC SuperScript 4200 Network Manual

Preparing the Printer

1. Turn off the printer, remove the power cord from the rear
of the printer, and disconnect the printer cable from the
port (A). Position the printer so you are facing the side
and back corner where the cable port is located. Make
sure that you have enough room to work.
2. Using a small phillips-head screw driver remove the two
screws from the Interface Panel (expansion slot) on the
rear of the printer (B), and pull out the Controller Board.
3. Remove the screw that holds the small 1.5" x 3.75" plate
over the Network Slot. Remove the plate. Keep the screw
(C).
Preparing the Printer
A
6 SuperScript Color Laser Network Guide

Installing the NIC

These steps are illustrated on the opposite page.
4. Two posts are used for fastening the NIC to the
Controller Board. Remove the screw from the lower one,
loosen the screw of the upper one and rotate the small
bracket (D). Avoid touching the Controller Board
circuitry and components!
5. Remove the NIC from its protective bag (E). Handle the
NIC only by its edges.
6. Hold the NIC so that its circuitry faces inside the printer
and its LED's face the back of the printer. Carefully align
the standoff pin with the lower right corner of the NIC.
7. Plug the NIC's connector to the Controller Board as
shown (F).
8. Use the mounting screws and bracket to fasten the NIC
to the standoff pins as shown. Attach the screw removed
from the front in step 3 (G).
9. Slide the Controller Board back in the expansion slot.
Reinstall and tighten the screws (H).
B
C
Network Slot