Extending The Cooling Down Time - Miele T 8428 C Operating Instructions Manual

Programmable functions
Extending the cooling down
time
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to handle.
The cooling down time
– can be extended by 5 minutes or 10
minutes.
– is not available for timed drying,
smoothing or handcare programmes.
Follow steps A to F to programme
and store in memory.
Before you begin, first ensure that:
– The tumble dryer is switched off.
– The door is closed.
48
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Press the I-On/0-Off button in.
Wait until the indicator light for the
Start/Stop button lights up
constantly . . .
C . . . and then release the Start/Stop
button.
D Press the Low temperature button
three times.
– The Low temperature indicator light
will briefly flash on and off seven
times.
– P and 0 (default setting) will flash
alternately in the display.
The number which appears alternately
in the display with P means:
0 Default setting
i The cooling down time will be five
minutes longer.
(The Automatic indicator light will
also flash once).
2 The cooling down time will be ten
minutes longer.
(The Automatic indicator light will
also flash twice).
E Pressing the Start/Stop button
switches from one to the other.
F Switch the dryer off with the
I-On/0-Off button.
The setting you have selected is now
stored in memory. You can change it
again at any time.