Extending The Cooling Down Time - Miele T 8402 C Operating Instructions Manual

Extending the cooling down
time
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to handle.
The dryer is delivered with the
extended cooling down time option
deactivated. You can extend the
cooling down time by 5 minutes or 10
minutes.
The option of extending the cooling
down time is available with the Cottons,
Minimum iron and Automatic
programmes.
Follow the steps ( , ,
programme and store in memory.
Before you begin, ensure that:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is at Finish.
Press the Start button and keep it
pressed in whilst carrying out steps
- .
Switch the dryer on.
Wait until the Start indicator lamp
lights up constantly . . .
. . . and then release the Start button.
The Cool air lamp will flash seven times.
– If the Drying indicator lamp is not
– If the Drying lamp flashes once:
– If the Drying lamp flashes twice:
...) to
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
^ Carry out steps
^ Switch the dryer off after checking
Programmable functions
Turn the programme selector to
Smoothing.
The flashing sequence of the
Drying lamp shows which option is
currently selected.
flashing: the cooling down time is
not extended (factory default
setting).
the cooling down time will be
extended by five minutes.
the cooling down time will be
extended by ten minutes.
Pressing the Start button switches
between the 3 options.
Switch the dryer off.
the setting as described above.
to .
47