Table of Contents
Advertisement
Levelling the machine
The machine must stand perfectly level
on all four feet and if the machine is
built under, the coverplate must also be
aligned horizontally underneath the
worktop, to ensure safe and proper
operation.
^ Turn the 4 screw feet to adjust the
dryer to the correct height and level.
,
The ventilation gaps in the plinth
must not be covered over as this
would prevent a sufficient intake of
air.
Room in which the dryer is located
Air taken in for use in the drying
process will be warm when it is
expelled from underneath the dryer.
This expelled air heats up the air in the
room. It is therefore very important to
ensure that the room is adequately
ventilated, particularly if the dryer is
located in a small room. Otherwise
running times and energy consumption
could be increased.
Washer-dryer stack
The tumble dryer can also be combined
with a Miele washing machine in a
washer-dryer stack. To do this the
appropriate stacking kit* (WTV) to match
your washing machine is required.
* accessory available to order
,
The stacking kit must be fitted by
suitably qualified fitter.
Before moving the machine again
(e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out, if the machine is tipped up when it is
being moved. It is a good idea to run the
Cool air programme for approximately 1
minute before moving the machine. Any
remaining condensed water will then be
fed into the condensed water container
or out through the drain hose.
Installation
39
Hide quick links:
Advertisement
Table of Contents
