Shortening the door panel
You can shorten the door panel to
match the height of adjacent kitchen
unit door fronts.
First of all you need to calculate
measurement X. This is the distance
from the lower edge of the tumble dryer
door to the lower edge of an adjacent
kitchen unit door front.
Procedure
^ Open the door.
^ First remove the door panel:
– to do this unscrew the 10 screws
(see arrows) from the machine door
plate.
^ Then remove the three decor strips
from the door panel.
^ Shorten the door panel and the two
side decor strips at the bottom by
measurement X using a suitable saw.
^ Drill four holes for securing the lower
decor strip into the door panel.
^ Fit the decor strips and the door
panel.
If you are intending to fit a decor panel,
check whether this will also need to be
shortened.
Installation
41