Miele G 674 Operating Instructions Manual page 48

Problem solving guide
Problem
The indicator light
"Inlet/Outlet" is flashing
shortly after the pro-
gramme has started
The indicator light
"Inlet/Outlet" comes on
during the "Energy
Save" programme
48
Possible cause
The stopcock is closed.
The water pressure at the
intake is lower than 0.3
bar.
The water inlet filter is
blocked.
The incoming water has
not reached the minimum
required temperature of
45 °C , the hot water
system may be
overloaded (see
"Programme selection").
Remedy
Open the stopcock fully.
If the programme still
does not start:
– Turn the programme
selector to the "Stop"
position.
– Switch the dishwasher
off using the "On/Off"
button.
– Start the programme
again.
Seek professional advice.
Before rectifying the
problem you must:
– Turn the programme
selector to the "Stop"
position.
– Switch the dishwasher
off using the "On/Off"
button.
then:
– Check the water inlet
filter and clean if
necessary.
– Start the programme
again.
– If the indicator light
comes on again select
a different programme.