Miele T 270 C Operating Instructions Manual page 31

Clean out
airways
Clean
out airways
Empty out
container
The fluff filters may be
blocked.
The condenser unit may be
blocked with fluff and
detergent residues.
Possible causes and remedies are described above in
(The Clean out airways lamp comes on).
There is no obvious cause. – Switch off the dryer.
The condensed water
container is full or there is
kink in the drain hose.
Remove any fluff (see
"Cleaning and care").
Please note that the
condenser unit must be
cleaned regularly (see
"Cleaning and care").
The check lamp will go out
when the door is opened.
– Then switch the dryer
back on and start the
programme again.
If the programme stops
again and the Clean out
airways lamp flashes, there
is a fault. Contact the Miele
Service Department.
– Empty out the
condensed water
container.
– Check the drain hose.
– Before starting a new
programme, first switch
the dryer off and then on
again.
31