Miele DA 360 Operating And Installation Manual page 11

Before any cleaning or maintenance
work disconnect the cooker hood
from the mains supply. Ensure that:
- it is switched off at the wall socket
and the plug has been withdrawn
(do not pull on the cable, only on
the plug), or
- the fuse has been withdrawn from
the fused spur connection unit, or
- the mains fuse is withdrawn, or
- the screw-out fuse is removed (in
countries where this is applicable).
Warning: The surfaces and controls
are susceptible to scratches and
abrasion. Please observe the
following cleaning instructions:
^ All external surfaces and controls can
be cleaned using warm water with a
little washing up liquid applied with a
well wrung out soft sponge or cloth.
Do not use too much water when
cleaning the controls. Water could
penetrate the into the electronics and
cause damage.
^ Wipe dry using a soft cloth.
Avoid:
– cleaning agents containing soda,
acids or chlorides,
– abrasive cleaning agents e.g.
powder cleaners or cream cleaners
and sponges, e.g. pot scourers or
sponges which have been previously
used with abrasive cleaning agents.
These will damage the surface
material.
The re-usable metal grease filter in the
appliance removes solid particles from
the kitchen vapours (grease, dust, etc)
preventing soiling of the cooker hood.
Clean the grease filter when it looks
dirty, and avoid letting it become so
dirty that the filtering effect is inefficient.
The grease filter should be cleaned
regularly to avoid a build-up of fat,
(approx. 3-4 weeks on average, but
sooner if necessary).
An over saturated filter is a fire
hazard.
If you are unsure about a particular
product or need further advice please
contact your nearest Miele Sales
office. See back page for address.
11