Advertisement
The necessary connection data and
model name are located on the hob
data plate.
Ensure that these match the household
mains supply.
When contacting the Service Depart-
ment, please quote the voltage, model
and serial numbers given on the data
plate.
Fit wall units and extractor hood be-
fore fitting the hob, to avoid damag-
ing the ceramic surface.
The veneer or laminate coatings of
worktops (or adjacent kitchen
units) must be treated with 100°C
heat-resistant adhesive which will not
dissolve or distort.
This appliance must not be in-
stalled over a dishwasher, washing
machine, tumble dryer, refrigerator,
freezer or fridge-freezer. The high tem-
peratures radiated by hobs could dam-
age the appliance below.
If the hob is built in above an oven,
the connection cable for the hob
must be positioned in such a way that it
cannot come into contact with the oven
housing.
22
Due to the high temperatures radi-
ated it is not advisable to fit a
drawer directly underneath the hob.
The hob may only be fitted above
kitchen units with fixed front panels. An
additional interim shelf should be fitted
underneath the hob.
When installing a hob there may be
a wall at the back and a wall or tall
unit at one side. On the other side there
must not be a unit or wall which stands
higher than the hob.
Due to the high temperatures radi-
ated by the hob, it is essential that a
minimum distance of 50 mm is main-
tained between the worktop cut-out
and
-
adjacent kitchen units
(e.g. tall unit)
-
the rear wall.
Hide quick links:
Advertisement
