Impulse Piping Connection Examples - YOKOGAWA Dpharp vigilantplant EJA Series Manual

Eja series differential pressure and pressure transmitters

Hide thumbs Also See for Dpharp vigilantplant EJA Series:

User manual (31 pages)

Table of Contents

(5) Condensate Pots for Steam Flow

Measurement

If the liquid in the impulse piping repeatedly condenses

or vaporizes as a result of changes in the ambient or

process temperature, this will cause a difference in the

fluid head between the high pressure and low pressure

sides. To prevent measurement errors due to these head

differences, condensate pots are used when measuring

steam flow.

(6) Preventing Wind Speed Effects in Very Low

Differential Pressure Measurement

IMPORTANT

When using a differential pressure transmitter to

measure very low pressures (draft pressure), the low

pressure connection port is left open to atmospheric

pressure (the reference pressure).

Any wind around the differential pressure transmitter

will therefore cause errors in the measurement. To

prevent this, it will be necessary either to enclose the

transmitter in a box, or to connect a impulse piping to

the low pressure side and insert its end into a wind

excluding pot (cylindrical with a base plate).

(7) Preventing Freezing

If there is any risk that the process fluid in the impulse

piping or transmitter could freeze, use a steam jacket or

heater to maintain the temperature of the fluid.

4.2

Impulse Piping Connection

Examples

Figure 4.6, 4.7, and 4.8 shows examples of typical

impulse piping connections. Before connecting the

transmitter to the process, study the transmitter

installation location, the process piping layout, and

the characteristics of the process fluid (corrosiveness,

toxicity, flammability, etc.), in order to make appropriate

changes and additions to the connection configurations.

Note the following points when referring to these piping

examples.

• If the impulse piping is long, bracing or supports

should be provided to prevent vibration.

• The impulse piping material used must be compatible

with the process pressure, temperature, and other

conditions.

• A variety of process pressure tap valves (main valves)

are available according to the type of connection

(flanged, screwed, welded), construction (globe, gate,

or ball valve), temperature and pressure. Select the

type of valve most appropriate for the application.

<4. Installing Impulse Piping>

Liguid

Orifice

Tap valve

Union

or flange

Tee

3-valve

manifold

Drain valve

Drain plug

Figure 4.6