Editing Multiple Parameters Simultaneously; Improved Parameter Resolution; Support For Windows Nt 4.0, 2000 & Me; Software Version Mismatch Warning - Yamaha DME 32 Owner's Manual

16

Editing Multiple Parameters Simultaneously

Previously, using DME Manager, only one parameter could be edited at a time. In Ver-
sion 1.5, up to eight parameters of the same type can be selected and edited simulta-
neously.
While holding down the Shift key, click the parameters that you want to edit.
1
The selected controls are highlighted by green boxes.
Release the Shift key when you've completed your selection.
2
Edit one of the selected parameters in the normal way.
3
All the selected parameters are edited.
Permanent links can be created between parameters by using the Link function.
the

Improved Parameter Resolution

The resolution of frequency, gain, and level parameters has been improved, offering
increased setting precision. PEQ and GEQ gain values, for examples, can now be set in
0.1 dB steps.
Support for Windows NT 4.0, 2000 & Me
In addition to the operating systems stated in the DME32 Owner's Manual, DME Man-
ager V1.5 supports Windows NT 4.0, 2000, and Me. With Windows NT, USB cannot be
used because it's not supported by that particular operating system.

Software Version Mismatch Warning

When DME Manager is started, it establishes communication with the DME32 and
checks to see if its version number matches that of the DME32 system software. If it
doesn't match, a warning message appears. You can still use the system even if this mes-
sage appears, although, normal performance cannot be guaranteed and operation may
be unreliable. For correct operation, the DME32 system software should be upgraded
to match that of DME Manager.
If the DME32 system software is a later version than DME Manager, no communica-
tions can be established during startup and the message "DME32 not found!" appears.
DME32—Owner's Manual Supplement
DME32 Owner's Manual
for more information.
See