Adding Voice Annotation To Saved Data (Ti25 And Tir1 Only) - Fluke Thermal Imagers Ti10 User Manual

Press the softkey labeled Up to display the previous image or Down to
4.
display the next stored image.
To delete a single Image from the SD card:
1. Perform the steps under viewing stored images above to bring the desired
image to the display.
2. Press the softkey labeled Select.
Press the softkey labeled Delete.
3.
To delete all the images from the SD card:
Press a to activate the menu.
1.
Press the softkey labeled Memory.
2.
Press the softkey labeled All Images.
3.
Adding Voice Annotation to Saved Data (Ti25
and TiR1 Only)
Voice annotation can only be added to an image prior to storing it. After
capturing an image, the Image Capture menu appears. To add a voice
annotation to the image:
Press the softkey labeled Audio.
1.
2. Press the softkey labeled Record to start the recording.
3. Speak into the Imager's microphone opening. Up to 60 seconds of audio
can be recorded for each image.
When done recording, press the softkey labeled Review to listen to what
4.
was recorded. When an audio recording has been created for an image, e
appears in the display while the image is displayed. To keep the audio
annotation, proceed to the next step. Otherwise, press the softkey labeled
Append or Replace to modify the recording before storing the image.
Once stored, the audio annotation can only be reviewed and not modified.
Press the softkey labeled Back to return to the Audio menu.
5.
Press the softkey labeled Store to store the measured data and audio
6.
annotation.

Adding Voice Annotation to Saved Data (Ti25 and TiR1 Only)

Thermal Imagers
11