Related Manuals for Fisher-Price H7185
Summary of Contents for Fisher-Price H7185
- Page 1 Swing Swing (Seat moves front to back) Cradle Cradle (Seat moves side to side) WARNING IMPORTANT! KEEP INSTRUCTIONS FOR FUTURE REFERENCE. H7185 www.fi sher-price.co.uk...
-
Page 2: Consumer Information
WARNING To prevent serious injury and/or falls and being strangled in the restraint system: • Always use restraint system. Never rely on the tray to restrain child. • Not recommended for children who can sit up by themselves (6 months approximately, until 9 kg/20 lbs). - Page 3 Motorized Frame Fabric Panel Lower Seat Tube 2 Upper Legs Note: Tighten the screws with the enclosed Allen wrench. #8 x 1,3 cm Screw - 2 Parts 4 Toys (toys may be different) Seat with Restraint System 2 Lower Legs 2 Feet M5 x 30 mm Bolt - 2 ALL SHOWN ACTUAL SIZE...
- Page 4 IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts. Lower Leg •...
- Page 5 Elbow Foot Button Red Dot • Locate the R and L on the underside of each elbow foot. The R indicates the right leg. The L indicates the left leg. • While pressing the upper button on the right leg, fit it into the tube in the motorized frame.
- Page 6 • Hook the two fastener straps on each side of the pad onto the rim on each side of the seat. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. © 2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
- Page 7 • First, fit an M5 lock nut into an opening in the short tube. Make sure the rounded side of the lock nut faces out. • Next, insert an M5 x 30 mm screw through the opening in the opposite side of the short tube. Fully tighten the screw with the Allen wrench.
-
Page 8: Battery Installation
Battery Installation Hint: If the swinging motion becomes noticeably slower, or sounds and lights become faint or stop, remove the batteries and replace them with four, new LR20 (“D”) alkaline batteries. Dispose of exhausted batteries properly. 1,5V x 4 LR20 (“D”) Battery Compartment Door Hint: We recommend using alkaline batteries for longer battery life. - Page 9 WARNING To prevent serious injury and/or falls and being strangled in the restraint system: • Always use restraint system. Never rely on the tray to restrain child. • Not recommended for children who can sit up by themselves (6 months approximately, until 9 kg/20 lbs).
- Page 10 PRESS Seat Tube TURN Cradle You can adjust the motion of the swing: side to side or front to back. • Press the seat tube button to unlock the seat tube. • Rotate the seat tube to the desired position. Press Seat Position Buttons You can adjust the seat to two different positions: Recline or Upright.
- Page 11 Swing, Waterglobe and Mobile Use Swing/Waterglobe/Mobile ON Waterglobe/ Mobile ON Music/Sounds Switch Volume Dial Swing • Turn the power dial to the ON position begins swinging. • Select any of six speed settings • Be sure to turn swinging OFF when not in use.
-
Page 12: Problems And Solutions
Problem Probable Cause Motor is not running; Power is not on no swinging Batteries incorrectly installed Dead batteries Need to start swinging motion Motor is running but swinging stops after a few minutes Swing motion setting is inappropriate for child’s weight Weak batteries Swing did not have sufficient time No difference noticed in...