Table of Contents
Advertisement
Adjustment of the image from the computer
This projector adjusts the format of the video signal supplied from the
computer. However, sometimes images are not projected correctly
owing to the type of the computer used. When the image from the
computer isn't projected correctly, press the AUTO POSITION button.
(See page 14.) If the image isn't projected correctly yet, adjust the
image from the computer using the menu.
In this menu, the setting value is not saved after turning off the
projector or when unplugging the signal cable. This menu is
prepared just for temporary use when AUTO POSITION does not
work correctly for the current provided signal.
opt.
SIGNAL
HORIZ. POSITION
VERT. POSITION
FINE SYNC.
TRACKING
COMPUTER INPUT
R G B
R G B
SET UP
To move the image horizontally :
Adjust HORIZ. POSITION in the SIGNAL menu. Press the
to move the image to the left. Press the
to the right.
To move the image vertically :
Adjust VERT. POSITION in the SIGNAL menu. Press the
move the image upward. Press the
downward.
When the image flickers or the image is out of focus :
Adjust FINE SYNC. in the SIGNAL menu.
SVGA60
0
0
0
0
RGB
OFF
button
button to move the image
button to
button to move the image
Simple adjustment method
1.
Select HORIZ. POSITION in the SIGNAL menu.
2.
Press the
or
button to adjust the horizontal start position
(or the left side of the image).
3.
Select TRACKING in the SIGNAL menu.
4.
Press the
or
button to adjust the horizontal end position (or
the right edge of the image).
5.
Repeat steps 1 to 4 for optimum adjustment results.
6.
Select VERT. POSITION in the SIGNAL menu.
7.
Press the
or
button to adjust the vertical start position (or
the upper edge of the image).
EN-19
Advertisement
Table of Contents
