Connection On An Already Installed Dish - Metronic zapbox twin Manual

Example for 2 dishes on Astra and Hotbird, Astra beeing connected to the input 2 (or
B) of the switch, and Hotbird beeing connected to 1 (or A):
Programmation
• Go in MENU / Installation / LNB Setup.
• On the Satellite line, select Hotbird with 34 arrows.
• On the DiSEqC switch line, select Tone A with 34 arrows.
• On the Store line, press OK to save this setting.
• On the Satellite line, select Astra1 with 34 arrows.
• On the DiSEqC switch line, select Tone B with 34 arrows.
• On the Store line, press OK to save this setting
• Press EXIT to quit the menus.
@
You can now watch channels
from both Astra (19) abd Hotbird
(see «Day to day operation»
page 19).
4 - Connection to an already installed dish
The receiver being disconnected from the mains, connect directly the LNB to the LNB receiver
input. Connect a scart lead from the television to the receiver TV output scart socket. Switch on
the television, connect the receiver on the power supply, the red LED is ON. Press the power
key ( ) of the remote control, the green LED lights on. Check in the list of the pre programmed
channels at the end of the user manual. You can select and watch the channel of this satellite.
13