Table of Contents
Advertisement
PROBLEMS AND SOLUTIONS GUIDE
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still
experience a problem, please contact Power Wheels
(EST) Monday through Friday and 11 AM - 5 PM (EST) Saturday. Or, contact your local Power Wheels
For the location nearest you, please visit us on-line at www.powerwheels.com, or call 1-800-348-0751.
PROBLEM
Vehicle does not run
Vehicle was running but
suddenly stopped
Consumer Relations, toll-free at 1-800-348-0751 between 9 AM and 7 PM
®
POSSIBLE CAUSE
Undercharged battery
Charger is not working
Tripped thermal fuse
Loose wire or loose connectors
Dead battery
Electrical switch damage
Motor damage
Loose wire or loose connectors
17
authorized service center.
®
SOLUTION
Charge the battery. A new battery should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the battery for
at least 14 hours after each use. Never charge the battery
longer than 30 hours.
Check all connectors. Make sure the battery connector is
tightly plugged into the charger connector, and that the
charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless
you have a volt meter. If you suspect there is a problem with
your charger, contact your local Power Wheels
service center. They can test your charger for you.
The built-in thermal fuse may "trip" and shut down operation of
the vehicle if the vehicle is overloaded or the driving conditions
too severe. Once a fuse has "tripped," remove your foot from
the pedal and wait approximately 25 seconds before operating
the vehicle again. To avoid repeated automatic shutdowns, do
not overload the vehicle by exceeding the 50 lb (23 kg)
maximum weight capacity or by towing anything behind the
vehicle. Do not drive up hills or run into fixed objects, which
can cause the wheels to stop spinning while power is still
being supplied to the motors. If a thermal fuse continually trips,
®
contact your local Power Wheels
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness connector
and that there are no loose wires around the motors.
If your battery is old or if you have not followed Battery
Care instructions, your battery may be dead. If you are
unsure whether or not the battery is dead, you can have
it tested at your local Power Wheels
service center.
The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact your local Power Wheels
service center for diagnosis and repair.
Contact your local Power Wheels
for diagnosis and repair.
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness con-
nector, and that there are no loose wires around the motors.
®
authorized
authorized service center.
®
authorized
®
authorized
®
authorized service center
P6830a-0920
Advertisement
Table of Contents
