Pc Cards; Inserting Pc Cards - Sharp PC-9800T Manual

PC Cards

Your notebook is equipped with two PC card slots which can accommodate two
Type II or one Type III card(s) conforming to the standards of the PCMCIA
(Personal Computer Memory Card International Association). When using a PC
card, see its manual.

Inserting PC Cards

You can insert/eject PC cards in the same way as floppy disks.
Type II
Upper
Lower
1. While sliding down the PC Card slot cover latch on the front side of your
notebook, open the PC card slot cover on the left side.
2. Insert the card into the appropriate slot with the label face up until it locks into
place. (You do not have to power off the notebook to handle PC cards when
using Windows 95). The PC card eject button pops up.
Notch
The labeled face up
Figure 6-1. Inserting and Ejecting PC Cards
If the card is installed correctly, you hear the pip twice. Only one pip
means that the PC card has not been recognized correctly. In this case,
install the PC card driver (see the end of this section).
PC Card Slot Compatibility
Type III ZV-port compliant CardBus compliant
PC Card Slot Cover Latch
PC Card Slot Cover
Hardware Expansion 6-1
6