Mazda RX-8 Smart Start Manual page 12

Audio Controls With Navigation
AUDiO SYSTEM ON
Push the Power/Volume button to
turn the radio on.
MEDiA SELECTiON
Push the SOURCE button to select
the appropriate on-screen button:
Radio: Select FM or AM button
for FM1, FM2, or AM band. The
selected band will be indicated in the
Information Display.
DiSC: Select for CD player.
SAT: Select for SIRIUS Satellite
®
radio. See the Owner's Manual for
more details.
AUX1: Select to switch to
auxiliary jack.
AUX2: Not used.
21
193096_10a_RX-8_SSG_050409.indd 22-23
TUNiNg
The radio has the following
tuning controls:
• Manual: Turn the
TUNE/AUDIO dial to manually
change the frequency.
• Seek/Track: Push and hold
the SEEK/TRACK buttons
to automatically seek a
higher or lower frequency
or track, depending on
media selected.
• Scan: Push the SCAN button
to automatically sample strong
stations for seconds each. Push
again to cancel.
• Preset Channel: Can be used
to store 8 AM, 16 FM and 18
SIRIUS ® Satellite stations.
1 Push the SOURCE button.
2 Select AM/FM or SAT.
3 Select AM, FM1, FM2, SAT1,
SAT2 or SAT3.
4 Tune to the desired station
using the SEEK/TRACK
button or by turning the
TUNE/AUDIO dial.
5 Select and hold any channel
preset on-screen button for
about two seconds until a
beep sound is heard.
• R epeat to store other stations.
• Auto Memory Tuning:
Select and hold the AUTO-M
on-screen button until beep is
heard to store an additional
8 stations on each FM and AM
band without disturbing the
previously stored stations. This
is useful when driving in an area
where the local stations are not
known. Refer to the Owner's
Manual for complete details.
Outside Temperature Display
Push OUTSIDE button to display
outside temperature in the
information display.
SETTiNg YOUR CLOCK
NOTE: gPS automatically sets
the clock, however, it may be
necessary to adjust hours in
different time zones or daylight
saving time.
1. Push the MENU button.
2. Select the Set Clock tab.
3. C hoose a 24-hour display or
a 12-hour display.
4. U se the + hour and - hour
tabs to enter the correct hour.
5. U se the +30 min (minutes) and
-30 min to move minutes ahead
or back by 30 minutes.
6. Push the OK tab to exit.
TO LOAD/PLAY A CD
1. P lace the ignition in the ACC
or ON position.
2. P ush
LOAD /
3. P ush the LOAD on-screen
button lightly.
4. W ait for the screen to lower.
5. Insert the CD after "IN"
is displayed on the
Information Display.
The CD will begin playing
after the screen closes.
22
5/4/09 9:49:36 AM