Fisher-Price POWER WHEELS H4803 Owner's Manual & Assembly Instructions page 12

F
15
• Fit and hold the brush guard against the front end of the vehicle.
Hint: Using the end of a Phillips screwdriver, poke a hole in the
thin, plastic covering over the lower holes in the brush guard.
• Insert two #10 x 1" screws through the lower holes in the brush
guard and into the vehicle. Tighten the screws.
A
Spacers
16
• Fit two spacers between the upper holes of the brush guard
and the front end of the vehicle
• Insert two #8 x 4" screws through the upper holes in the
brush guard, through the spacers and into the front end of the
vehicle B . Tighten the screws.
12
Brush Guard
#8 x 4"
B
Screws
.
A
ASSEMBLY
Short Seat
Belt Strap
T-Loops
Slot
Seat
17
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through the slot
near the outer edge of the seat. Make sure the side of the seat
belt with the fastener faces the outer edge of the seat.
• Pull the short seat belt strap completely through the slot until the
last T-loop at the opposite end of the belt catches against the slot.
You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat belt strap.
T-Loop
Fastener End
18
• Insert each fastener end of the long seat belt strap through a
slot in the center of the seat. Make sure the fasteners face the
outer edge of the seat.
• Pull each side of the long seat belt strap evenly through the
slots. Make sure to pull each T-loop through a slot.
• Turn the seat upright.
T-Loop (Pull through slot)
Fastener End
Slot
Long Seat Belt Strap
H4807pr-0922 H4807pr-0922