General Control - Sharp SD-AT1000W Operation Manual

General control

SD-AT1000W
ENGLISH
Display
E-17
" To change the display brightness (2 levels)
You can switch the display brightness by press-
ing the DIMMER button.
" Volume control
Main unit operation:
When the VOLUME control is turned clockwise,
the volume will increase. When it is turned anti-
clockwise, the volume will decrease.
Remote control operation:
Press the VOLUME + button to increase the vol-
ume and the VOLUME - button for decreasing.
" Muting
The volume is muted temporarily when pressing
the MUTING button on the remote control.
Press again to restore the volume.
" Headphones
! Before plugging in or unplugging the headphones, reduce the volume.
! Be sure your headphones have a 6.3 mm (1/4") diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
! Plugging in the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME control.
! You cannot use the surround feature with headphones.
! Do not plug in or unplug headphones whilst recording. The sound may skip.
04/7/21 SD-AT1000W_LAG_E2.fm
Dimmed
.....
0 1 2 39 40
TINSZA121AWZZ