Table of Contents
Advertisement
IMPORTANT! The battery must be removed from your vehi-
cle for the initial charge in order to complete assembly. You
do not need to remove the battery from your vehicle to
recharge it.
Battery
Clamp
• Using a Phillips screwdriver, loosen the screws in the
battery clamp. Remove the battery clamp from the
vehicle body.
• Remove the Power Wheels
from the battery compartment.
1
25 Amp Fuse
• Insert a 25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of the
battery when properly installed.
Battery Charging
®
6 Volt (4.0 Amp/Hr.) battery
2
Charger
Connector
• Plug the charger connector into the battery connector.
3
• Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is "ON".
• Before first time use, charge the battery for at least
18 hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use
of your vehicle. Do not charge the battery longer than
30 hours.
• Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the charger
from the wall outlet. The battery is now charged and is
ready to be installed in your vehicle. Please see "Battery
Installation" on page 14 for detailed battery installation
instructions.
7
Charger
Battery
Connector
Advertisement
Table of Contents
