Antenna - LG Zenith HCS5610 Installation And Operating Manual

Antenna Hookup
Connect an off-air antenna to the HD Integrator Box System.
Locate the Antenna/Cable jack on the back
1
of the HD Integrator Box System.
Connect the antenna wire (Flat or Round)
2
that runs from the wall to this jack,
according to one of the diagrams shown to
the right.
After all connections are complete, plug in
3
the TV. The HD Integrator Box System is
designed to operate on AC power.
If the antenna is a 75 ohm RF cable, then no
adapters are required.
A 300 to 75 ohm adapter is not included with
the Zenith HD Integrator Box System.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking
through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
300 TO 75 OHM
ADAPTER
on one end and a round opening with a wire sticking out on the other end.
Flat Wire
(300 ohm)
300/75 ohm
Adapter
RF Coaxial Wire
(75 ohm)
AC OUT AC IN
AUDIO IN AUDIO OUT RS-232C
REMOTE
IN
RJP
INTERFACE
AUX 1 2 DIGITAL DIGITAL AUDIO DISPLAY
DIGITAL MAX 8A 960W AC 120V~ 60Hz
CONTROL VIDEO IN VIDEO OUT OUT (OPTICAL) CONTROL
AUDIO IN AUDIO OUT
REMOTE
IN
RJP
INTERFACE
1 2
AUX DIGITAL
DIGITAL
CONTROL VIDEO OUT
VIDEO IN
Connections Panel
AUDIO IN AUDIO OUT
REMOTE
IN
RJP
INTERFACE
1 2
AUX DIGITAL
DIGITAL
CONTROL VIDEO OUT
VIDEO IN
Connections Panel
P A G E 1 1