Aux Controller: Connection And Placement; Ir Receiver & Ir Bracket Installation - LG Zenith HCS5610 Installation And Operating Manual

AUX Controller: Connection and Placement

Connect the AUX Controller to allow the Integrator Box to operate your AUX device.
1
Connect the AUX Controller to the AUX CONTROL cord on the TV/STB.
Place the AUX Controller under and in front of the AUX device.
2
The AUX Controller must extend just out in front of the infrared sensor on the AUX device.
*Note:
If the infrared sensor is not marked on your AUX device, shine a flashlight into the front panel of the AUX device to locate
the sensor.
IR Receiver & IR Bracket Installation
Install the IR Receiver and Bracket Assembly to the back of the monitor using the method described below.
The IR Receiver should be installed in the IR Bracket. When the IR Bracket assembly is attached to the TV, it
should be mounted with two-sided tape on the bottom-back side of the TV. The IR receiver should be aimed
toward the TV viewer and be visible at the bottom front of the TV, in order that it be able to receive IR sig-
nals from the user remote.
IR Receiver & Bracket Installation
THE IR RECEIVER UNIT IS PROVIDED. THIS WILL NEED TO BE MOUNTED ON THE MONITOR BACK WITH TWO-SIDED TAPE.
P A G E 1 0
AUDIO IN AUDIO OUT
REMOTE
IN
RJP
INTERFACE
1 2
AUX DIGITAL
DIGITAL
CONTROL VIDEO OUT
VIDEO IN
AUX Controller
IR Sensor
DVD (Front View)
Monitor
IR Receiver
IR Bracket
AUDIO IN
REMOTE
IN
RJP
INTERFACE
1
AUX
DIGITAL
CONTROL
VIDEO IN
AC OUT AC IN
RS-232C
DIGITAL AUDIO DISPLAY
MAX 8A 960W AC 120V~ 60Hz
OUT (OPTICAL) CONTROL
Connections Panel
DVD
(Side View)
AC OUT AC IN
AUDIO OUT RS-232C
2
DIGITAL DIGITAL AUDIO DISPLAY
MAX 8A 960W AC 120V~ 60Hz
VIDEO OUT OUT (OPTICAL) CONTROL
Connections Panel
1/2"
to 1"