Furniture Guard; Brush Roll Belt - Sanitaire 800 Series Owner's Manual

How To Change Furniture Guard
Four screws on the underside of the base secure the furniture
guard.To gain access to the two rear screws, you must remove
the four screws holding the two axle clamps and remove
the rear wheel assembly. The front two screws are exposed
by removing the soleplate and brush roll. Remove the four
furniture guard screws, install the new guard and tighten the
four screws. Reinstall the brush roll, soleplate and rear wheel
assembly.
Brush Roll
The rotating brush roll sweeps and combs the carpet nap.
Keep the brush roll free from hair and threads so it will continue
brushing the carpet nap. Replace worn brush strips when the
bristles no longer touch a straight edge held across the bottom
plate. There are two types of brush rolls, the chromed steel tubular
brush roll or the anodized aluminum spiral brush roll. Follow the
instructions for the type of brush roll featured on the cleaner.
CAUTION: Turn off the switch and unplug the
electrical cord before replacing brush
strips.

Brush Roll Belt

The brush roll belt on the upright vacuum cleaner drives the
brush to agitate, sweep, and comb the carpet nap. The belt
should be checked regularly to be sure it is in good condition.
Replace the belt if it is stretching, cracking, or slipping. Cut away
any hair or thread wound around the brush roll or the belt pulley
because the buildup could cause the belt to rotate unevenly.
6
How to Replace A Worn Belt
CAUTION: Turn off the switch and unplug the
electrical cord before replacing belt.
Belt pulleys can become hot during
normal use. To prevent burns, avoid
touching the belt pulley when servicing
the drive belt.
IMPORTANT: Improper installation of the brush roll
or brush roll belt could cause carpet
or cleaner damage.
1. Release cam locks to remove
2. Pull up on belt to rotate it off the
Belt
guide
3. Place new belt around brush roll.
4. Align brush roll pulley with belt guide.
5. Place rubber end cap covers
over both end caps (flat side
against end cap). Align holes
and secure.
6. Align end caps with slots in
cleaner base. Push brush roll
into base.
8 8
Ask for GENUINE EUREKA replacement belts - No. 52100.
bottom plate.
motor pulley. Lift up on brush
roll and remove worn belt.
Fan Cover
Motor Pulley
Brush Roll Pulley
7. Place lower side of belt into
belt guide and pull to stretch
the belt around the left side of
motor pulley. Rotate pulley to
secure belt into groove.
8. Place slots of bottom plate
over tabs of cleaner base.
Seat and secure cam locks
(refer to 1).
GENUINE
Look for the
EUREKA PRODUCT
symbol.