Troubleshooting; Basic Checks; Bios Setup; Slow Drive Performance - SanDisk 5000 Product Manual

SSD SATA 5000 2.5"

Troubleshooting

8.1

Basic Checks

8.2
Most disk problems are caused by improper disk installation. If a problem
arises, the following should be checked:
Cable:
Improper cable has been used
o
Cables are too long to support the transfer rate
o
Improper cable connection to the device
o
Device connector: Improperly locked
Power supply: Below SSD requirements

BIOS Setup

8.3
Verify that the disk is enabled in the BIOS. In most new BIOSs, there is
an option for drive auto-identification.

Slow Drive Performance

8.4
Poor disk performance may be due to one of the following:
Check that Write Caching is enabled in the drive under the category
Properties.
© 2008 SanDisk® Corporation 18 July 2008, Document No. 80-11-01488
Product Manual
Rev 0.7