Koolatron TotalChef Directions For Use

CLEANING AND MAINTENANCE

1. To clean the glass board, use a damp cloth or sponge.
DO NOT use anything abrasive to clean and DO NOT place device into
the sink with water pouring directly on it.
2. To clean the control board, use a damp cloth.

ERROR CODES

The following codes may appear in the display panel (6):-
E1 or E2 There is a problem with the electronic control.
Turn off the unit, wait a few minutes and start again.
E3 or E4 The unit is over-heating.
Turn off the unit, allow it to cool down and then recommence operation.
E5 Check the power supply, there is a lack of required voltage
E6 Check the power supply, the voltage is too high for the unit.

TROUBLE SHOOTING

Problem Solution
The cooker stops after • Check if the pan is being used properly.
continuous use but emits • Check if the pan is centered on the glass board.
squeaky sound for • Check if the diameter of the pan base is
about 30 seconds.
Problem Solution
The heating stopped • Check if the temperature surrounding
suddenly when in use.
• Check if the air vent hole is blocked.
Problem Solution
The temperature cannot • Check if the base of the pan used is
be controlled while
the product is on. • Check if the central part of the pan is sunken.
• Check if the heat indicator light is on.
Koolatron International
Unit C3 Knights Park, Knight Road, Strood, Rochester
Kent, ME2 2LS, United Kingdom
Telephone: 01634 29 73 83 • Fax: 01634 29 73 74
at least 12cm.
the device is too high.
flat enough.