Surface Burners; Air Shutter Adjustment - Jenn-Air Pro-Style CVG4380 Use And Care Manual

Your new cooktop burners have been preset for an "average" set of conditions. Regional
variances in gas pressure and atmospheric conditions such as height above sea level
may affect your initial flame performance.
When the control knob is turned ON, gas enters the mixer tube and mixes with air. This
air and gas mixtureflows to the burner head and is lighted by a spark from the solid state
igniter.
A properly adjusted burner with clean ports will light within a few seconds. The cone-
shaped flame will be clear blue in color with a clearly defined inner cone. There should
be no trace of yellow in the flame. A yeJ)ow flame indicates an improper mixture of air and
gas. If your flame does not resemble the "correct" flame as described above, follow the
air shutter adjustment instructions below.
The variable surface contro_sfor the surface burners and grill burner provide flexibility in
setting seleCtion.
Note: The grill can be replaced with an optional surface burner module, Model AG2O2.
Surface Burners
In case ef prolonged power failure, you can manually light the surface burner by holding
a lighted match nearthe burner ports and slowly turningthe control knobcounterclockwise
(after depressing) until the gas ignites. There is no fan so smoke and condensation can
gather.
Grill
IN CASE OF POWER FAILURE OR IF THE DOWNDRAFT FAN IS INOPERABLE, DO
NOT USE GRILL. VENTILATION SYSTEM WILL NOT OPERATE.
Air Shutter Adjustment
To Adjust Surface Burner Air Shutter (Some models):
Loosen fastening screw with a phillips screw- SURFACE BURNER ROTATE AIR
driver and rotate air shutter to increase or de- AfR SHOrtER SHU_E_ ON
MqXER HEAD TC
crease the size of the air opening. As the shut- SCREW MAKE AiR
ter is turned observe change inflame appear- --_ xt_ "_'-A_A_R SHUT-Ea
ance. Adjustment is satisfactorywhen a c,eady A,RO "_____..._,,
defined, even blue flame results atthe Hi flame To
TO _,d CLOS5
setting. After adjustment, tighten screw. OPEN _#"
8