Jenn-Air Pro-Style CVG4380 Use And Care Manual page 10

• Since the controls are a push-turn type, they must be pushed in before turning. To
set (from the OFF"position), push in on control knob and immediately turn counter-
clockwise to the LITE position until burner ignites. After ignition, turn knob clockwise
to desired setting.
• Igniterwillcoetinuetosparkuntilknobistumedcleckwisebacktoorpast Hiposition
on knob,
r r
@® ©
\ \ \ '\ ,\ / /
1. 2. FAN 3. 4. & 6,
1. Left rear surface burner or grill. Note: When using an AG202 surface
2. Leftfront surface burner or grill burner assemblywithcontrollocations
3. Center rear surface burner. #1 and #2, the control knob may be
4. Center front surface burner, turned to a position lower than the Lo
5, Right rear surface burner, setting. (The Lo setting is set for the
6. Right front surface burner, grill burner.)
The size and type of cookware and the amount and type of food being cooked will
influence the setting needed for best results. The setting indicated should serve as a
guide while you become familiarwith your cooktop.
Use the HI flame setting to quickly bring foods to a boll or
to begin a cooking operation. Then reduce to a lower _(_
setting to continue cooking. Neverleave food unattended
over a Hi flame setting.
Med setting is used to continue a cooking operation. Food
will notcook any faster when a higher flame setting is
used than that needed to maintain a gentle boil Re-
member, water boi/s at the same temperature whether
boiling gently or vigorously.
@
Use Lo setting to keep food at serving temperatures with- _
out further cooking. Youmay find that some cooking may _
take place if the cookware is covered.
10