Locking the Camera
Network Configuration
Setting IP
Connecting the Camera to a Personal Computer
Use soft, lint-free cloth to wipe the dome cover clean and remove fingerprints.
Attach the inner liner and camera housing.
Turn the power on after you have installed the camera.
This is a network-based camera and must be assigned an IP address first.
The camera' s default IP address is 192.168.0.2 and sub mask is 255.255.255.0. To change
IP address, open Network Settings page described later.
If your network uses a DHCP server, an IP address can be assigned automatically from the
DHCP server by enabling DHCP in the Network Settings page described later.
1.
Connect the network cable to the camera and then turn on the camera' s power.
Safety Wire (Fall Prevention Wire, not
supplied)
6