Table of Contents
Advertisement
Secure the camera bottom case (1) to the wall/ceiling with the TP4 x 15 mm tapping screws,
supplied.
Insert the power cable, LAN cable and Audio cables.
Adjust the view angle (zoom, focus, and Horizontal Rotation).
To prevent the camera from falling off, ensure that it is connected to a firm place
(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not
supplied).
Pay also careful attention to the length, strength, wiring, and material (insulating
Warning
properties) of the fall prevention wire to be used. The length should be as short
as possible within the permissible range of the mounting length. The wire
should be strong enough to withstand the total weight of this product. (Pay also
attention to the finishing at the end of the wire.)
Must be isolated camera and the wall/ceiling which are connected by the Safety
Caution
Wire (Fall Prevention Wire).
Depending on the material of your mounting surface, you may require different
Note
screws and anchors than thos e supplied.
Safety Wire (fall prevention
wire is not supplied).
Please tighten a safety wire
on a firm place as figure.
5
Advertisement
Table of Contents
