Connect The Ac Adaptor - Roland Classic C-200 Owner's Manual

Getting Ready to Play

Connect the AC adaptor

1.
Turn the [VOLUME] knob all the way to the left to
minimize the volume.
2.
Connect the included power cord to the AC
adaptor.
The indicator will light when you plug the AC
adaptor into an AC outlet.
Place the AC adaptor so the side with the indicator
(see illustration) faces upwards and the side with
textual information faces downwards.
3.
Connect the AC adaptor to the DC IN jack on the C-200's rear panel.
4.
Plug the power cord connected to the AC adaptor into an electrical outlet.
• Depending on the region, the included power cord may differ from the one shown.
• If you won't be using the C-200 for an extended period of time, disconnect the power cord from the electrical outlet.
Ground Terminal
Depending on the circumstances of a particular
setup, you may experience a discomforting
sensation, or perceive that the surface feels gritty to
the touch when you touch this device, microphones
connected to it, or the metal portions of other
objects, such as guitars. This is due to an
infinitesimal electrical charge, which is absolutely
harmless. However, if you are concerned about this,
connect the ground terminal (see figure) with an
external ground. When the unit is grounded, a
slight hum may occur, depending on the particulars
of your installation. If you are unsure of the
connection method, contact the nearest Roland
Service Center, or an authorized Roland distributor, as listed on the "Information" page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event of lightning)
16
AC adaptor
Power cord
Indicator
AC Outlet
Ground terminal