Changing The Presser Feet; How To Remove And Insert The Needle - JUKI HZL-30Z Instruction Manual

Changing The Presser Feet

1.
Raise the presser foot.
HZL-30Z
HZL-60

How To Remove And Insert The Needle

1.
Removing the needle.
Needle clamp
screw
(1) Turn the handwheel toward you to until
the needle bar reaches its highest
position.
(2) Loosen the needle clamp screw.
Needle to be purchased
When purchasing spare needles,
specify HAx1 (130/705H) for
household sewing machine or
HAx1SP (needle for knits).
11
2.
Push the presser foot
release lever.
HZL-30Z
Push
HZL-60
2.
Attaching the needle.
(The needle cannot be inserted unless it is correctly positioned.)
Hold the needle with its flat part facing
away from you, and insert it fully until it
touches the stopper pin.
Needle size
The larger the number,
the thicker the needle.
CAUTION:
Make sure to disconnect the plug from the wall
outlet before changing the presser foot.
3.
Align the presser foot
pin with the marker line on
needle plate.
HZL-30Z
Pin
Marker line
HZL-60
CAUTION:
Make sure to disconnect plug from wall
outlet before inserting needle.
Stopper pin
The flat
part should
face away
from you.
Securely tighten the needle clamp screw,
using the screwdriver furnished with the
machine.
Checking the needle
Parallel
Level plate
4.
Lower the presser foot.
HZL-30Z
HZL-60
Screwdriver
* Check the needle for its
straightness occasionally.
Any bent needle would
cause stitch skipping,
thread breakage or damage
to materials.