Jet JMS-10CMS Operating Instructions And Parts Manual page 17

Quick-cam Miter Table Lock Adjustment
Referring to Figure 13:
1. Place the quick-cam miter lock (A) in the down
position to lock.
2. Loosen the lock nut (D) with a 13mm wrench,
then turn the stop nut (E) to extend the locking
arm against the base of the miter saw.
3. Test the quick-cam miter lock (C) to verify that
it locks the table securely into position.
4. Tighten the lock nut (D) to lock the miter
locking mechanism into place.
Figure 13
Cutting Arm Pivot Adjustment
The raising and lowering of the cutting arm should
be free of side-to-side play for accurate miter cuts.
It should be tight enough to prevent side-to-side
movement while still allowing the arm to move
freely up and down when cutting.
Referring to Figure 14:
If the cutting arm (A) is too loose, tighten by turning
the cutting arm adjusting nut (B) clockwise with a 19
mm wrench to tighten.
If cutting arm travel is too tight, turn the cutting arm
adjusting nut counterclockwise.
Figure 14
Laser Beam
The laser is turned on with a switch located on the
saw handle (C, Fig. 15). When left on indefinitely, a
sensor will turn the laser off after 20 minutes. The
switch must be reset (turned off for two seconds,
then on again) to restart.
The laser has no adjustments and should not
require adjustment. If adjustment should become
necessary, take the miter saw to an approved
service center.
• Laser radiation. Avoid direct eye exposure.
Always un-plug miter saw from power
source before making any adjustments.
•
Laser Warning Label: Max output <1mW
DIODE LASER: 522-542nm, Complies with
21CFR 1040.10 and 1040.11.
Use of controls or adjustments
or performance of procedures other than those
specified in this
hazardous radiation exposure.
The use of optical instruments
with this product will increase eye hazard.
•
Do not attempt to repair or disassemble the
laser. If unqualified persons attempt to
repair this laser product, serious injury may
result. Any repair required on this laser
product should be performed by authorized
service center personnel.
17
manual may result in