Warning - Jet HVBS-56M Operating Instructions And Parts Manual

Warning

Read and understand the entire instruction manual before operating machine.
This bandsaw is designed and intended for use by properly trained and experienced personnel
only. If you are not familiar with the proper and safe use of a bandsaw, do not use until proper
"Warning: For you own safety read instruction manual before operating saw."
a) Wear eye protection.
b) Do not remove jammed cut off pieces until blade has stopped.
c) Maintain proper adjustment of blade tension, blade guides, and thrust bearing.
d) Adjust upper guide to just clear workpiece.
e) Hold workpiece firmly against table.
1. Keep guards in place and in working order.
2. Remove adjusting keys and wrenches. Form a habit of checking to see that keys and adjusting
wrenches are removed from the machine before turning it on.
3. Keep work area clean. Cluttered areas and benches invite accidents.
4. Don't use in dangerous environment. Don't use power tools in damp or wet locations, or expose them
to rain. Keep work area well lighted.
5. Keep children away. All visitors should be kept a safe distance from the work area.
6. Make your workshop child proof with padlocks, master switches or by removing starter keys.
7. Don't force tool. It will do the job better and more safely at the rate for which it was designed.
8. Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for
which it was not designed.
9. Use proper extension cord. Make sure your extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in voltage resulting in loss of power and overheating. Table 1
shows the correct size to use depending on cord length and nameplate ampere rating. If in double,
use the next heavier gage. The smaller the gage number, the heavier the cord.
10. Wear proper apparel. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry
which may get caught in moving parts. Nonslip footwear is recommended. Wear protective hair
covering to contain long hair.
11. Always wear approved safety glasses/face shields while using this bandsaw. Also use face or dust
mask if cutting operation is dusty. Everyday eyeglasses only have impact resistant lenses; they are
NOT safety glasses.
12. Secure work. Use clamp or vise to hold work when practical. It is safer than using your hand and it
frees both hands to operate tool.
13. Don't overreach. Keep proper footing and balance at all times.
14. Maintain tools with care. Keep tools sharp and clean for the best and safest performance. Follow
instructions for lubricating and changing accessories.
15. Disconnect tools before servicing; when changing accessories such as blades, bits, cutters, and the
like.
16. Reduce the risk of unintentional starting. Make sure switch is in off position before plugging in.
17. Use recommended accessories. Consult the owner's manual for recommended accessories. The use
of improper accessories may cause risk of injury to persons.
18. Never stand on tool. Serious injury could occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
training and knowledge have been obtained.
4