Janome MC 11000 Instructions Manual page 22

ET2
Resume Mode
1
Touch creen Calibration
2
Format
Built-in Memory
3
ATA PC Card
U B Memory
4
Reset all to defaults
(C)
Resume last pattern?
(A)
Touch Screen Calibration
PRESS MARK (+).
Format Memory?
All the stored data will be erased.
5 inch/mm
Yes
Yes
Yes
Yes
Yes
X
Register
(B)
Touch Screen Calibration
END
Built-in
X
inch mm
1 Resume Mode
When Resume Mode is enabled, the last pattern
sewn before turning the power off will be resumed
when the power is turned on again.
To enable Resume Mode, press the on/off key to
check the box on.
When you turn the power on, the confirmation
window will open.
Press the OK key to resume the last sewn pattern.
NOTE:
If you switch from the embroidery mode to the ordinary
sewing mode or vice versa before turning the power off,
Resume Mode will be disabled.
2 Touch screen calibration
If you think the touch panel keys are out of alignment,
you can correct it in the key position adjustment
window.
When you press the key, window (A) will be shown.
With your finger, press the black cross as it appears in
order. When you press the last black coss, the window
(B) will be shown. The window will close and go back to
the original screen with the new setting being
registered.
3 Formatting the memory
If the internal memory, ATA PC card or USB memory
key does not function due to damage to the memory
bank, you need to re-enable it by formatting the
memory.
4 Resetting all to default
Press the yes key to reset all the parameters to the
original values (factory settings).
5 Inch/mm options
You can set your machine's measuring unit to either
inch or millimeter by pressing the "inch" or "mm" key.
The default unit setting is millimeter.
21