Rear Panel Features - ION OMNI PLAY Quick Start Manual

QUICKSTART GUIDE
Make sure that the items listed below are included in the box:
o
OMNI PLAY Turntable
Quickstart Guide
READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT
o
Go to http://www.ionaudio.com for product registration.
o

REAR PANEL FEATURES

1. POWER CABLE – Plug this cable into a power
source.
2. ANTENNA – Fully extend this antenna to enhance
radio reception.
TURNTABLE FEATURES
1. PLATTER – Place your record here.
2. TRANSPORT SCREW – Tighten this screw
before using the turntable!
this screw secures the platter and tonearm
assembly to prevent damage during transport.
If you transport the turntable, loosen the screw
to re-secure the platter and tonearm assembly.
3. 45 RPM ADAPTER HOLDER – Holds the
included 45 RPM adapter. When not using the
adapter, please place it in this holder.
4. TONEARM – OMNI PLAY comes with a ready
to use pre-balanced TONEARM and cartridge.
The TONEARM can be raised and lowered by
hand, or by pressing the RAISE / LOWER
LEVER. Please note that the TONEARM needs
to be moved away from resting position (on the
ARM CLIP) for the turntable motor to activate.
When the TONEARM is placed back in its
resting position,
deactivate.
5. ARM CLIP – This specially designed arm clip
secures the tone arm while at rest or when not in
use. The arm clip has been designed to remain
in the up position while unlocked.
6. RAISE / LOWER LEVER – Raises and lowers
the tonearm.
7. 33 / 45 / 78 RPM SWITCH – This switch controls the RPM of the turntable platter.
45 RPM Adapter
Safety Instructions & Warranty Information
When loosened,
the turntable motor
IMPORTANT
Remove the plastic cartridge cover (needle
cover) before operating the turntable.
will
Tighten the TRANSPORT SCREW before
using the turntable.
screw secures
assembly to prevent damage during transport.
If you transport the turntable, loosen the screw
to re-secure the platter and tonearm assembly.
1
When loosened, this
the platter and tonearm